Lenze 8400 motec - Manual (Page 75)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 75
4 Device control (DCTRL)
4.2 Device state machine and device states
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.6 OperationEnabled
In the "OperationEnabled" state
• is the controller if the controller inhibit is deactivated and no trouble ("Trouble") and fault
("Fault") are existent.
• the operation is enabled and the motor follows the setpoint defined by the active application
(with sensorless vector control only after magnetisation has been completed).
Depending on certain conditions, a status change takes place based on the "OperationEnabled" de-
vice status.
Related topics:
 wDriveControl control word ( 211)
LED status display Display in C00137 Display in status word 1 ( C00150 )
Bit 11 Bit 10 Bit 9 Bit 8
OperationEnabled 0 1 0 1
Change condition Changeover to the device status
Control bit "EnableOperation" in control word wDriveControl = "0"
OR terminal RFR = LOW level (controller inhibit).
SwitchedOn
Control bit "SwitchOn" = "0". ReadyToSwitchOn
Undervoltage in the DC bus. Trouble / Fault (depending on C00600/1 )
Error with error response "Trouble" occurs. Trouble