5 device identification, Device identification, 2introduction: parameterising the controller – Lenze 8400 motec User Manual
Page 29
Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
29
2
Introduction: Parameterising the controller
2.5
Device identification
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.5
Device identification
For device identification, any device name (e.g. wheel drive) with max 32 characters can be set in
for the controller and saved in the memory module with mains failure protection.
2.5.1
Automatic acceptance of the device name in the »Engineer«
If a device name is stored in
and the controller is added to the project in the »Engineer«
via the Einfügen Insert device detected online... function, the device name stored in
("8400 motec")
(here: wheel drive) is used as device name instead of the type:
This mechanism also functions in reverse direction:
If you rename the controller in the project view via <F2>, you will be asked afterwards if you want to
: