Lenze 8400 motec - Manual (Page 59)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 59
4 Device control (DCTRL)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to get to the parameterisation dialog of the device control:
1. »Engineer« Go to the Project view and select the 8400 motec controller.
2. Go to Workspace and change to the Application parameters tab.
3. Go to the Overview dialog level and click the Drive interface button.
Parameterisation dialog in the »Engineer«
The parameterisation dialog shows the input / output signals and the internal signal flow of the
LS_DriveInterface system block which displays the device control in the application:
Range / Meaning Display parameter
 Display of the internal state machine and the current device status C00137
 Display of all active sources of a controller inhibit C00158
 Display of all active sources of a quick stop C00159
 Display of the status word of the device control C00150