Lenze 8400 motec - Manual (Page 297)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 297
9 Diagnostics & error management
9.8 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.8 Error messages of the operating system
This chapter describes all error messages of the controller operating system and possible causes &
remedies.

Tip!
Each error message is also saved to the logbook in chronological order.
 Logbook ( 289)
9.8.1 Structure of the 32-bit error number (bit coding)
If an error occurs in the controller, the internal fault memory saves a 32-bit value which contains the
following information:
[9-1] Structure of the error number
• Display parameter: C00161/1
• The LS_DriveInterface system block shows the 32-bit error number at the outputs wStateDeter-
mFailNoLow (Low Word) and wStateDetermFailNoHigh (High Word).
• For the sake of legibility, the error number in the logbook and in C00165/1 is displayed with the
following syntax:
[Error type].[Error subject area no.].[Error ID]
9.8.1.1 Error type
The error type gives information about the behaviour/response of the controller to the error. The er-
ror type for some device errors can also be parameterised.
 Reserved
 Error type
 Error subject area
 Error ID
2 1 0 3
Bit 16 25 26 31 0 15 29 30
Bit 29 Bit 28 Bit 27 Bit 26 Meaning
0 0 0 0 0: No response
0 0 0 1 1: Fault
0 0 1 0 2: Trouble
0 1 0 0 4: WarningLocked
Bit 16 25 26 31 0 15 29 30