Lenze 8400 motec - Manual (Page 415)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 415
11 Parameter reference
11.2 Parameter list | C01351
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01351
Parameter | Name:
C01351 | ACDrive: Control word
Data type: UNSIGNED_16
Index: 23224 d = 5AB8 h
From version 04.01.00
Display of the "AC Drive profile" control word for the 8400 motec
• If required, you can set an inversion for individual control bits in C00890/1 which is included in this display.
• Detailed information on the "AC Drive Profile" can be found in the EtherNet/IP™ communication manual.
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Run Forward Connections between Run1 and Run2 and trigger events
can be found in the EtherNet/IP™ communication
manual.
Bit 1 Run Backward
Bit 2 Fault Reset 0->1 ≡ Reset error
0 ≡ No response
Bit 3 Reserved
Bit 4 Reserved
Bit 5 NetCtrl
Run/Stop control
0 ≡ Run/Stop control via local setting in the device or
terminal
1 ≡ Run/Stop control via network (e.g. from the scanner)
Bit 6 NetRef Status of the reference speed / reference torque
0 ≡ Reference via local setting in the device or terminal
1 ≡ Reference via network (e.g. from the scanner)
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Info
C01351/1 ACDrive: Control word
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT