Lenze 8400 motec - Manual (Page 350)

11 Parameter reference
11.2 Parameter list | C00105
350 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00105
C00106
C00107
Parameter | Name:
C00105 | Decel. time - quick stop
Data type: UNSIGNED_32
Index: 24470 d = 5F96 h
The set deceleration time determines the ramp slope at quick stop
• When the output frequency falls below the threshold set in C00019 , the DC injection brake DCB is activated.
Note:
The S-ramp time set in C00182 is also active with quick stop!
In order to reach the required deceleration time for quick stop, set the time accordingly lower in this parameter.
Setting range
(min. value | unit | max. value) Lenze setting
0.0 s 999.9 5.0 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00106 | Auto DCB: Hold time
Data type: UNSIGNED_32
Index: 24469 d = 5F95 h
Hold time of the automatic DC injection brake
• The DC injection brake is applied for the time set here if the value falls below the speed setpoint set in C00019 .
 DC-injection braking
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 999.0 0.5 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00107 | DCB: Hold time
Data type: UNSIGNED_32
Index: 24468 d = 5F94 h
Maximum hold time of the manual DC injection brake
• A time can be set here after which the DC injection brake is switched off automatically to prevent the motor from
thermal overload.
 DC-injection braking
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 999.0 999.0 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000