Lenze 8400 motec - Manual (Page 341)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 341
11 Parameter reference
11.2 Parameter list | C00034
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00034
C00036
C00039
Parameter | Name:
C00034 | AINx: Configuration
Data type: UNSIGNED_8
Index: 24541 d = 5FDD h
Configuration of the analog input for current or voltage measurement
 Analog terminals
Selection list Info
0 0...+10 V(-10V...+10V) Input signal is voltage signal 0 V ... +10 V
• 0 V ... +10 V ≡ 0 % ... +100 %
1 0...+20mA With external load resistor (250 Ohms):
Input signal is the current signal 0 mA ... 20 mA
• 0 mA ... 20 mA ≡ 0 % ... +100 %
2 4...+20mA With external load resistor (250 Ohms):
Input signal is the current signal 4 mA ... 20 mA
• 4 mA ... 20 mA ≡ 0 % ... +100 %
• The current loop is monitored for open circuit
(I < 4 mA) by the device.
3 AIn1 - AIn2 Voltage difference (-10 V ... +10 V) between input AIn1
and input AIn2
• Selection is only sensible when using an
E84DGFCXxNx Communication Unit (no fieldbus;
extended terminal design).
Subcodes Lenze setting Info
C00034/1 0: 0...+10 V(-10V...+10V) AIN1: Config.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00036 | DCB: Current
Data type: INTEGER_16
Index: 24539 d = 5FDB h
Braking current in [%] based on rated device current ( C00098 )
 DC-injection braking
Setting range (min. value | unit | max. value) Lenze setting
0.0 % 100.0 50.0 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00039 | Fixed setpoint x (L_NSet_1 n-Fix)
Data type: INTEGER_16
Index: 24536 d = 5FD8 h
The L_NSet_1 FB: Fixed speed setpoints (JOG values) for the setpoint generator
Setting range (min. value | unit | max. value)
-199.9 % 199.9
Subcodes Lenze setting Info
C00039/1 40.0 % Fixed setpoint 1
C00039/2 60.0 % Fixed setpoint 2
C00039/3 80.0 % Fixed setpoint 3
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100