Lenze 8400 motec - Manual (Page 320)

10 Communication
10.3 Control mode "Network (MCI/CAN)"
320 Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.3 Control mode "Network (MCI/CAN)"
40: Network (MCI/CAN)" can be selected as a control mode in C00007 in order to quickly and easily
set-up controller control via fieldbus communication.
In this control mode, the process data (PDOs) are transferred via the MCI or CAN interface depend-
ing on the available communication unit.
• Max. 8 process data words per direction are exchanged.
• The process data are accessed via the LP_Network_In and LP_Network_Out port blocks. These
port blocks are also called process data channels.
[10-1] External and internal data transfer between bus system, controller and application
/3B0FL,Q /3B0FL2XW
:RUG

:RUG
:RUG

:RUG
)LHOGEXV

$SSOLFDWLRQ
&RPPXQLFDWLRQPRGXOH
0&,LQWHUIDFH

Preconfigured wiring of the internal interfaces in control mode "Network (MCI/CAN)" is
shown in figure [] . ( 226)