H3C Technologies H3C Intelligent Management Center - Manual (Page 149)

135
Figure 83 Application Traffic area layout
Application Traffic area fields:
• Application Traffic trend graph—Shows changes of inbound and outbound Solaris traffic over the
last 1 hour. The green curve shows the inbound traffic and the orange curve shows the outbound
traffic. To change the report period, click the Last 1 Hour icon
on the upper right of the graph,
and then select an icon from the list. Available options include the Last 6 Hours icon , Today icon
, Yesterday icon , This Week icon , This Month icon , and This Year icon . Point to
a spot on the curve to view the application traffic at the specific time point. Click Rx or Tx to display
or hide the corresponding monitor index in the graph.
• Attribute/Value—Monitor index name and data that was obtained when APM last polled Solaris.
{
Last Hour's Traffic—Total traffic sent and received by Solaris over the last 1 hour.
{
Today's Traffic—Total traffic sent and received by Solaris since 00:00 today.
Network Interface
The Network Interface area layout is shown in Figure 84 .
Figure 84 Network Interface area layout
Network Interface area fields:
• Interface Name—Identifier of a network interface card in Solaris. APM monitors both physical and
virtual (logical) network interface cards.
• Receive Rate—Receive rate of a network interface card in the last APM polling period.
{
Set Threshold—Click the Set Threshold icon to set alarm thresholds for the receive rate of
Solaris network interface cards. The data is highlighted in orange when it the receive rate
reaches the level-1 threshold, and is highlighted in red when the receive rate reaches the level-2
threshold. You can set global thresholds or custom thresholds. For information about setting the
thresholds, see " 6 Configuration management ."
• Send Rate—Send rate of a network interface card in the last APM polling period.