H3C Technologies H3C Intelligent Management Center - Manual (Page 512)

498
of the application in the dependency topology. APM automatically adds the dependencies
between the directory and operating system applications by IP address and displays their
dependencies in the application topology.
{
Detect Application—Select this parameter if you want to enable application detection.
Application detection enables APM to verify connection to the application by using the previous
parameter settings, and to determine whether to add the application monitor based on the
verification result. APM adds the application monitor only when it can connect to the
application. When this parameter is not selected, APM adds the application monitor without
verifying the connection.
5. Click OK.
Modifying a directory monitor
Operators can modify all parameters except the IP address of a directory monitor. If the IP address of the
host where the monitored directory is located changes, operators must add a new application monitor
for the directory. However, the new application monitor cannot inherit the history data from the previous
application monitor.
To modify a directory monitor:
1. Click the Resource tab.
2. Select Application Manager > Application Monitor from the navigation tree.
The application monitor list page displays all application monitors.
3. Click the Modify icon for the directory monitor you want to modify.
The page for modifying the directory monitor appears.
4. Modify the following parameters for the application monitor:
{
IP Address—Cannot be modified.
{
Name—Modify the unique application monitor name. H3C recommends using Application
name_host IP address for naming the application monitor.
{
Description—Modify the description for the application monitor.
{
Polling Interval (min)—Select a polling interval for the application monitor. Available options
include 1, 2, 3, 4, 5, 10, 20, and 30. The default polling interval is 5 minutes. A shorter polling
interval provides more accurate real-time data, but consumes more system resources.
{
Monitor Type—Select the protocol (SSH, Telnet, or WMI) through which APM monitors the
directory application, and then click the
Configure link (not available for WMI) to configure
related parameters.
SSH parameters
− Edit SSH Parameters—Select this option if you want to manually configure SSH parameters
for APM. Make sure the SSH settings are the same as those on the operating system where
the directory is located.
− Select an Existing Template—Select this option if you want to select an existing SSH
template for APM. For information about setting SSH parameter templates, see H3C IMC
Base Platform Administrator Guide.
− Authentication Mode—Select the authentication mode for SSH users. Options include
Password, Private Key, Password + Private Key, Password + Super Password, Private Key +
Super Password, and Password + Private Key + Super Password. The following parameters
to be configured vary with authentication modes.