H3C Technologies H3C Intelligent Management Center - Manual (Page 521)

507
{
Contact—Modify the contact information, such as name, email address, and telephone number.
The default is the username of the operator who created the application monitor.
{
Related Applications—Modify the application that the SNMP service depends on. Enter the
complete or part of the application monitor name in the Search field at the top of the window,
and click Search. Select the application that the SNMP service depends on, and then click OK.
Operating system applications, such as Windows, AIX, SCO UNIX, FreeBSD, OpenBSD,
HP-UX, Solaris, Mac OS, and Linux, cannot be selected. Operators can view all dependencies
of the application in the dependency topology. APM automatically adds the dependencies
between SNMP service and operating system applications by IP address and displays their
dependencies in the application topology.
To remove the relationship between the SNMP service and the specified application, select the
application in the Related Applications field, and then click Delete.
{
Detect Application—Select this parameter if you want to enable application detection.
Application detection enables APM to verify connection to the application by using the previous
parameter settings, and to determine whether to modify the application monitor based on the
verification result. APM modifies the application monitor only when it can connect to the
application. When this parameter is not selected, APM modifies the application monitor without
verifying the connection.
5. Click OK.
Viewing the SNMP service application monitor report
After adding the SNMP service application monitor, APM collects application index data to calculate its
availability and health status. Obtain monitor indexes for SNMP by viewing the monitor report.
To access the SNMP service application monitor report:
1. Click the Resource tab.
2. Select Application Manager > Application Monitor from the navigation tree.
The application monitor list page displays all application monitors.
3. Click the link naming an SNMP application monitor.
The monitor report of SNMP appears, as shown in
Figure 416 . For information about the icons in
the monitor report, see " 2 Quick start ." This section describes the fields in each area of the monitor
report.
Figure 416 Part of an SNMP service application monitor report
Monitor Information
The Monitor Information area layout is shown in Figure 417 .