H3C Technologies H3C Intelligent Management Center - Manual (Page 505)

491
4. Modify the following parameters for the application monitor:
{
IP Address—Cannot be modified.
{
Name—Modify the unique application monitor name. H3C recommends using Application
name_host IP address for naming the application monitor.
{
Description—Modify the description for the application monitor.
{
Polling Interval (min)—Select a polling interval for the application monitor. Available options
include 1, 2, 3, 4, 5, 10, 20, and 30. The default polling interval is 5 minutes. A shorter polling
interval provides more accurate real-time data, but consumes more system resources.
{
Monitor Type—Select the protocol (SSH, Telnet, or WMI) through which APM monitors the file
application, and then click the
Configure link (not available for WMI) to configure related
parameters.
SSH parameters
− Edit SSH Parameters—Select this option if you want to manually configure SSH parameters
for APM. Make sure the SSH settings are the same as those on the operating system where
the file is located.
− Select an Existing Template—Select this option if you want to select an existing SSH
template for APM. For information about setting SSH parameter templates, see H3C IMC
Base Platform Administrator Guide.
− Authentication Mode—Select the authentication mode for SSH users. Options include
Password, Private Key, Password + Private Key, Password + Super Password, Private Key +
Super Password, and Password + Private Key + Super Password. The following parameters
to be configured vary with authentication modes.
− Username—Enter the SSH username. The user must have the operating system
administrator's privilege.
− Password—Enter the password of the SSH user.
− Private Key File—Enter the directory of the SSH private key file or browse to the file.
− Private Key Password—Enter the password to decrypt the SSH private key file.
− Super Password—Enter the super password with which an SSH user can elevate privileges
after login.
− Port—Enter the SSH port on the operating system.
− Timeout (1-120 seconds)—Enter the maximum time period that APM waits for an SSH
response from the operating system. The value range is 1 to 120 seconds and the default is
10 seconds. If no SSH response is received from the operating system within the timeout time,
APM considers the interaction a failure.
− Retries (1-5)—Enter how many times APM retries to send SSH packets to the operating
system host.
Telnet parameters
− Edit Telnet Parameters—Select this option if you want to manually configure Telnet
parameters for APM. Make sure the Telnet settings are the same as those on the operating
system where the file is located.
− Select an Existing Template—Select this option if you want to select an existing Telnet
template for APM. For information about setting Telnet parameter templates, see H3C IMC
Base Platform Administrator Guide.
− Authentication Mode—Select the authentication mode for Telnet users. Options include
Password (No Operator or Super/Manager), Username + Password, Super/Manager