H3C Technologies H3C Intelligent Management Center - Manual (Page 478)

464
of the application in the dependency topology. APM automatically adds the dependencies
between the SOAP-based Web service and operating system applications by IP address and
displays their dependencies in the application topology.
To remove the relationship between the SOAP-based Web service and the specified
application, select the application in the Related Applications field, and then click Delete.
{
Detect Application—Select this parameter if you want to enable application detection.
Application detection enables APM to verify connection to the application by using the previous
parameter settings, and to determine whether to modify the application monitor based on the
verification result. APM modifies the application monitor only when it can connect to the
application. When this parameter is not selected, APM modifies the application monitor without
verifying the connection.
5. Click OK.
Viewing the SOAP-based Web service application monitor
report
After adding the SOAP-based Web service application monitor, APM collects application index data to
calculate its availability and health status. Obtain monitor indexes for the SOAP-based Web service by
viewing the monitor report.
To access the SOAP-based Web service application monitor report:
1. Click the Resource tab.
2. Select Application Manager > Application Monitor from the navigation tree.
The application monitor list page displays all application monitors.
3. Click the name link of a SOAP-based Web service application monitor.
The monitor report of SOAP-based Web service appears, as shown in
Figure 386 . For information
about the icons in the monitor report, see " 2 Quick start ." This section describes the fields in each
area of the monitor report.
Figure 386 Part of a SOAP-based Web service application monitor report