H3C Technologies H3C Intelligent Management Center - Manual (Page 482)

468
16 LDAP service monitor
This chapter describes how to add and modify LDAP service application monitors, and how to view
relevant monitor reports.
Active Directory service
Active Directory (AD) is a directory service developed based on Lightweight Directory Access Protocol
(LDAP) to run on the Windows Server operating systems. Administrators can easily locate the objects
stored in the AD.
APM supports monitoring the running status of the AD service. This section describes how to add and
modify the application monitor for the AD service and helps you view the monitor report.
Adding an AD service application monitor
APM monitors the AD service through WMI. Before adding an AD application monitor, complete the
following tasks:
• Add AD service hosts to the IMC platform so APM can obtain and display network connections of
the hosts and their access devices in the application topology. For more information about adding
hosts to the IMC platform, see H3C IMC Base Platform Administrator Guide.
• Obtain the correct username and password of the user who has the Windows Server
administrator's privileges.
• To view traffic statistics in the monitor report of the AD service application, make sure at least one
probe is configured in APM. After an AD service application monitor is added, APM sends the IP
address and service port of the monitored AD service application to the probes for traffic collection.
To add an AD service application monitor:
1. Click the Resource tab.
2. Enter the Add Application page in one of the two following ways:
{
Select Application Manager > Add Application from the navigation tree.
The page displays all application types that can be monitored by APM.
{
Select Application Manager > Application Monitor from the navigation tree, and click Add on
the application monitor list page.
3. Click Active Directory of the LDAP Service Monitor class.
The page for adding an AD service application monitor appears.
4. Configure the following parameters:
{
IP Address—Enter the IP address of the host on which the AD service application to be
monitored is installed. If the host is already added to the IMC platform, you can also click Select
and select the host in the Select Devices window. For information about selecting a host, see "
2
Quick start ." APM automatically checks the specified IP address and associates the application
monitor with the host managed in the IMC platform.