PLANET XGS3-24040 - Manual (Page 574)

XGS3 Command Guide
38-3
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: Enable the switch, and display PIM-DM state-refresh timer information in detail.
Example:
Switch #debug ip pim timer srt
Remark: Other debug switches in PIM-DM are common in PIM-SM, including debug pim event, debug
pim packet, debug pim nexthop, debug pim nsm, debug pim mfc, debug pim timer, debug pim state, refer
to PIM-SM manual section.
38.2.3 ip mroute
Command: ip mroute <A.B.C.D> <A.B.C.D> <ifname> <.ifname>
no ip mroute <A.B.C.D> <A.B.C.D> [<ifname> <.ifname>]
Function: To configure static multicast entry. The no command will delete some static multicast entries or
some egress interfaces.
Parameter: <A.B.C.D> <A.B.C.D> are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Default: To delete this static multicast entry, if the command isn’t included interface parameter.
Command Mode: Global Mode.
Usage Guide: The <ifname> should be valid VLAN interfaces. The multicast data flow will not be
forwarded unless PIM is configured on the egress interface and the interface is UP. If the state of the
interface is not UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be
fordwarded. To removed the specified multicast routing entry. If all the egress interfaces are specified, or
no interfaces are specified, the specified multicast routing entry will be removed. Otherwise the multicast
routing entry for the specified interface will be removed.
Example:
Switch(config)#ip mroute 10.1.1.1 225.1.1.1 v10 v20 v30
38.2.4 ip pim bsr-border
Command: ip pim bsr-border
no ip pim bsr-border
Function: To configure or delete PIM BSR-BORDER interface.
Parameter: None.
Default: Non-BSR-BORDER.
Command Mode: Interface Configuration Mode.
Usage Guide: To configure the interface as the BSR-BORDER. If configured, BSR related messages will
not receive from or sent to the specified interface. All the networks connected to the interface will be
considered as directly connected.
Example:
Switch(Config-if-Vlan1)#no ip pim bsr-border