PLANET XGS3-24040 - Manual (Page 339)

25-52
Command Mode:
Interface Configuration Mode.
Default:
By default, destination address for DHCPv6 relay is not configured.
Usage Guide:
This command is used to configure the DHCPv6 relay for the specified interface, the address
should be the address of another DHCPv6 relay or the address DHCPv6 server. At most three relay
addresses can be configured for an interface. To be mentioned, the DHCPv6 relay stops working
only if all the relay destination address configurations have been removed. This command is
mutually exclusive to
25.15 ipv6 dhcp server
Command:
ipv6 dhcp server <poolname> [preference <value>] [rapid-commit] [allow-hint]
no ipv6 dhcp server
Function:
This command configures the address pool which will be allocated by the DHCPv6 server through t
he specified interface. The no form of this command will remove the address pool configuration.
Parameters:
<poolname> is a string with its length less than 32, which designates the name of the address pool
which is associated with the specified interface. If the rapid-commit option has been specified, the
DHCPv6 server send a REPLY packet to the client immediately after receiving the SOLICIT packet.
If the preference option has been specified, <value> will be the priority of the DHCPv6 server, with
its value allowed between 0 and 255, and with 0 by default, the bigger the preference value is, the
higher the priority of the DHCPv6 server. If the allow-hint option has been specified, the client
expected value of parameters will be appended in its request packets.
Command Mode:
Interface Configuration Mode.
Default:
DHCPv6 address pool based on port is not configured by default.
Usage Guide:
This command configure the DHCPv6 address pool which is applied by the DHCPv6 server for the
specified interface, as well as optional parameters. One port only can configure the one DHCPv6
address pool.
Example:
Switch(Config-if-Vlan1)#ipv6 dhcp server PoolA preference 80 rapid-commit allow-hint
25.16 ipv6 general-prefix
Command:
ipv6 general-prefix <prefix-name> <ipv6-prefix/prefix-length>
no ipv6 general-prefix <prefix-name>
Function:
To define an IPv6 general prefix. The no form of this command will delete the configuration.