PLANET XGS3-24040 - Manual (Page 264)

17-22
None.
Usage Guide:
This command creates a virtual tunnel interface. Since there is not information such as specific
tunnel mode and tunnel source, show ipv6 tunnel does not show the tunnel, enter tunnel mode
after creating, under that model information such as tunnel source and destination can be specified.
No command is to delete a tunnel.
Example:
Create tunnel 1.
Switch(Config)#interface tunnel 1
17.2.29 show ip traffic
Command:
show ip traffic
Function:
Display statistics for IP packets.
Command mode:
Admin Mode
Usage Guide:
Display statistics for IP, ICMP, TCP, UDP packets received/sent.
Example:
Switch#show ip traffic
IP statistics:
Rcvd: 3249810 total, 3180 local destination
0 header errors, 0 address errors
0 unknown protocol, 0 discards
Frags: 0 reassembled, 0 timeouts
0 fragment rcvd, 0 fragment dropped
0 fragmented, 0 couldn't fragment, 0 fragment sent
Sent: 0 generated, 3230439 forwarded
0 dropped, 0 no route
ICMP statistics:
Rcvd: 0 total 0 errors 0 time exceeded
0 redirects, 0 unreachable, 0 echo, 0 echo replies
0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp, 0 timestamp replies
Sent: 0 total 0 errors 0 time exceeded
0 redirects, 0 unreachable, 0 echo, 0 echo replies
0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp, 0 timestamp replies
TCP statistics:
TcpActiveOpens 0, TcpAttemptFails 0
TcpCurrEstab 0, TcpEstabResets 0