Chapter 37 commands for ecmp, 1 maximum-paths, Maximum – PLANET XGS3-24040 User Manual
Page 571: Paths

Commands for Multicast Protocol Content
37-1
Chapter 37 Commands for ECMP
37.1 maximum-paths
Command: maximum-paths <1-32>
no maximum-paths
Function: This command is used to configure the maximum-paths which support the equivalence
multi-paths. The no command restores the default configuration.
Parameter: <1-32>: At present, users can configure the multi-paths number from 1 to 32. When
configure 1, it is equal to disable ECMP function. In addition, the actual configuration number is the
power of 2 that approaches and is bigger than the user input value.
Command mode: Global Mode.
Default: The default number is 4.
Usage Guide: None.
Example: Configure the maximum-paths of the equivalence multi-paths as 8.
Switch(config)# maximum-paths 8