PLANET XGS3-24040 - Manual (Page 523)

35-236
35.22 bgp log-neighbor-changes
Command: bgp log-neighbor-changes
no bgp log-neighbor-changes
Function: Output log message when BGP neighbor changes. The “no bgp log-neighbor-changes”
command cancels this configuration.
Parameter: None.
Default: Not configured.
Command Mode: BGP route mode
Usage Guide: Can display neighbor change messages on the monitor.
Example:
Switch(config-router)# bgp log-neighbor-changes
35.23 bgp network import-check
Command: bgp network import-check
no bgp network import-check
Function: Set whether check the IGP accessibility of the BGP network route or not. The “no bgp
network import-check” command sets to not checking the IGP accessibility.
Parameter: None.
Default: Not configured.
Command Mode: BGP route mode
Usage Guide: Checking the IGP accessibility of the route advertised by BGP is to check the existence of
next-hop and its IGP accessibility.
Example:
Switch(config-router)# bgp network import-check
35.24 bgp rfc1771-path-select
Command: bgp rfc1771-path-select
no bgp rfc1771-path-select
Function: After this attribute is set, path selecting will follow the way defined in rfc 1771, namely not
checking the AS internal metric, or comparing the internal METRIC.
Parameter: None.
Default: Following
Command Mode: Global mode
Usage Guide: After this attribute is set, path selecting will follow the way defined in rfc 1771, namely not
checking the AS internal metric, when different AS exist, which should be perform without this attribute
set.