PLANET XGS3-24040 - Manual (Page 82)

XGS3 Command Guide
1-82
Download files to the FTP client.
Parameter:
<source-url> is the location of the source files or directories to be copied; <destination-url> is the destination
address to which the files or directories to be copied; forms of <source-url> and <destination-url> vary depending
on different locations of the files or directories. ascii indicates the ASCII standard will be adopted; binary indicates
that the binary system will be adopted in the file transmission（default transmission method）.When URL represents
an FTP address, its form should be:
ftp://<username>:<password>@{<ipaddress>|<ipv6address>|<hostname> }/<filename>,amongst <username> is the
FTP user name,<password> is the FTP user password,<ipaddress>|<ipv6address> is the IPv4 or IPv6 address of
the FTP server/client,<hostname> is the name of the host mapping with the IPv6 address,it does not support the file
download and upload with hosts mapping with IPv4 addresses,<filename> is the name of the FTP upload/download
file.
Special keywords of the filename
Keywords
Source or destination addresses
running-config
Running configuration files
startup-config
Startup configuration files
nos.img
System files
nos.rom
System startup files
Command Mode:
Admin Mode.
Usage Guide:
This command supports command line hints, namely if the user can enter commands in following forms: copy
<filename> ftp:// or copy ftp:// <filename> and press Enter, following hints will be provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >
ftp username>
ftp password>
ftp filename>
Requesting for FTP server address, user name, password and file name
Examples:
(1) Save images in the FLASH to the FTP server of 10.1.1.1, FTP server username is Switch, password is superuser
Switch#copy nos.img ftp://Switch:[email protected]/nos.img
(2) Obtain system file nos.img from the FTP server 10.1.1.1, the username is Switch, password is superuser
Switch#copy ftp://Switch:[email protected]/nos.img nos.img