PLANET XGS3-24040 - Manual (Page 844)

60-5
60.13 debug ntp authentication
Command: debug ntp authentication
no debug ntp authentication
Function: To display NTP authentication information, the no form command disabled the switch of
displaying NTP authentication information.
Parameter: None.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: To display NTP authentication information, if the switch is enabled, and if the packets
schlepped authentication information when the packet in sending or receiving process, then the key
identifier will be printed out.
Example: To enable the switch of displaying NTP authentication information.
Switch# debug ntp authentication
60.14 debug ntp packet
Command: debug ntp packet [send | receive]
no debug ntp packet [send | receive]
Function: To enable/disable the debug switch of displaying NTP packet information.
Parameter: send: The debug switch of sending NTP packet.
receive: The debug switch of receiving NTP packet.
If there is no parameter, that means should enable the sending and receiving switch of NTP
packet in the same time.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example: To enable the debug switch of displaying NTP packet information.
Switch# debug ntp packet
60.15 debug ntp adjust
Command: debug ntp adjust
no debug ntp adjust
Function: To enable/disable the debug switch of displaying local time adjust information.
Parameter: None.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example: To enable the debug switch of displaying local time adjust information.
Switch# debug ntp adjust