PLANET XGS3-24040 - Manual (Page 622)

XGS3 Command Guide
38-51
Reset Count
The reset count of MSDP Peer.
Peer Name
The description of MSDP Peer.
Active SA
The numbers of active SA.
TLV sent/received
The statistics of TLV messages sent and received
from the Peer.
38.4.36 shutdown
Command: shutdown
no shutdown
Function: Disable specified MSDP Peer.
Parameter: None.
Command Mode: MSDP Peer Configuration Mode.
Default: Enabled.
Usage Guide: When configuring a MSDP Peer with multiple commands, sometimes it is required that
these commands should be effect together but not one by one. The shutdown command can be used to
disable the peer before configuration and the no shutdown used after configuration in order to make the
peer configuration effect together. The shutdown command will remove all the TCP sessions with the
specified MSDP Peer as well as the statistics.
Example:
Switch(config)#router msdp
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# shutdown
38.4.37 ttl-threshold
Command: ttl-threshold <ttl>
no ttl-threshold
Function: To configure the minimum TTL value of multicast source encapsulated in SA message.
Parameter: ttl：minimum TTL value，range between 1 to 255.
Command Mode: MSDP Configuration Mode.
Default: TTL value will not be filtered when TTL value is 0.
Usage Guide: The redistribution of multicast datagrams can be controlled through the TTL value. SA
messages will be advertised only if the TTL value in the packet is less than the TTL threshold.