PLANET XGS3-24040 - Manual (Page 783)

47-1
Chapter 47 Commands for RADIUS
47.1 aaa enable
Command: aaa enable
no aaa enable
Function: Enables the AAA authentication function in the switch; the "no AAA enable" command disables
the AAA authentication function.
Command mode: Global Mode.
Parameters: No.
Default: AAA authentication is not enabled by default.
Usage Guide: The AAA authentication for the switch must be enabled first to enable IEEE 802.1x
authentication for the switch.
Example: Enabling AAA function for the switch.
Switch(config)#aaa enable
47.2 aaa-accounting enable
Command: aaa-accounting enable
no aaa-accounting enable
Function: Enables the AAA accounting function in the switch: the "no aaa-accounting enable" command
disables the AAA accounting function.
Command mode: Global Mode
Default: AAA accounting is not enabled by default.
Usage Guide: When accounting is enabled in the switch, accounting will be performed according to the
traffic or online time for port the authenticated user is using. The switch will send an “accounting started”
message to the RADIUS accounting server on starting the accounting, and an accounting packet for the
online user to the RADIUS accounting server every five seconds, and an “accounting stopped” message
is sent to the RADIUS accounting server on accounting end. Note: The switch send the “user offline”
message to the RADIUS accounting server only when accounting is enabled, the “user offline” message
will not be sent to the RADIUS authentication server.
Example: Enabling AAA accounting for the switch.
Switch(config)#aaa-accounting enable
47.3 aaa-accounting update
Command: aaa-accounting update {enable|disable}
Function: Enable or disable the AAA update accounting function.
Command Mode: Global Mode.
Default: Enable the AAA update accounting function.
Usage Guide: After the update accounting function is enabled, the switch will sending accounting
message to each online user on time.
Example: Disable the AAA update accounting function for switch.