PLANET XGS3-24040 - Manual (Page 804)

52-2
Default: Not configured.
Usage Guide: This command configures the reflector port for the destination of mirror data grams, and
disables the MAC learning function of the specified port. The configuration of reflector port is to change
the mode of the local port from the destination port mode to be the reflector mode. Hence, the
configuration of reflector port and the destination port are exclusive. The no command is used to restore
the reflector port to normal port. The source port, in access or trunk mode, should not be added to
RSPAN VLAN. When the reflector port is configured as springboard of CPU TX direction mirroring, it
must be configured as TRUNK port and allows the RSPAN VLAN data passing, the Native VLAN should
not be configured as RSPAN VLAN.
Example:
Switch(config)#monitor session 1 reflector-port ethernet1/3