PLANET XGS3-24040 - Manual (Page 664)

XGS3 Command Guide
38-93
Example:
Switch(config)#ip igmp proxy unsolicited-report interval 3
38.11.13 ip igmp proxy unsolicited-report robustness
Command: ip igmp proxy unsolicited-report robustness <value>
no ip igmp proxy unsolicited-report robustness
Function: To configure the retry times of upstream ports’ sending unsolicited reports. Parameter: value:
<2~10>. The retry time for upstream ports’ sending unsolicited report is limited between 2 and 10.
Command Mode: Global Mode.
Default: Retry time is 2 by default.
Usage Guide: The upstream ports re-transmit the unsolicited reports in order that the router will not miss
the report packet due to link down or packet loss.
Example:
Switch(config)#ip igmp proxy unsolicited-report robustness 3
38.11.14 ip igmp proxy upstream
Command: ip igmp proxy upstream
no ip igmp proxy upstream
Function: Enable the appointed IGMP Proxy upstream port function. The “no ip igmp proxy upstream”
disables this function.
Command Mode: Interface Configuration Mode.
Default: Disabled.
Usage Guide: To configure the interface to function as the upstream port of IGMP Proxy. In order to
make IGMP Proxy work, at least one downstream interface should be configured. The “no ip igmp proxy
upstream” command will disable the configuration.
Example: Enable IGMP Proxy upstream port function in interface VLAN1 under interface configuration
mode.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp proxy upstream
38.11.15 ip multicast ssm
Command: ip multicast ssm range {<1-99>| default}
no ip multicast ssm
Function: To configure the address range for IGMP Proxy ssm multicast groups; the no form of this
command will delete the ssm multicast groups.
Parameter: default: show the address range 232/8 for ssm multicast groups.
<access-list-number> is the applied access list number, range is 1-99.
Command Mode: Global Mode.
Default: The default address range is 232/8 for ssm multicast groups.