PLANET XGS3-24040 - Manual (Page 142)

8-8
Example:
Check the statistics of LLDP data packets after LLDP is enabled on the switch.
Switch(config)#show lldp traffic
PortName Ageouts FramesDiscarded FramesInErrors FramesIn FramesOut
TLVsDiscarded TLVsUnrecognized -------------- ------- --------------- --------------
-------- --------- ------------- ----------------
Ethernet1/1 0 0 0 0 7 0
0
8.14 show lldp interface ethernet
Command:
show lldp interface ethernet <IFNAME>
Function:
Display the configuration information of LLDP on the port, such as: the working state of LLDP Agent.
Parameters:
<IFNAME>: Interface name.
Default:
Do not display the configuration information of LLDP on the port.
Command Mode:
Admin Mode, Global Mode.
Usage Guide:
Users can check the configuration information of LLDP on the port by using “show lldp interface
ethernet XXX”.
Example:
Check the configuration information of LLDP on the port after LLDP is enabled on the switch.
Switch(config)#show lldp interface ethernet 1/1
Port name: ethernet 1/1
LLDP Agent Adminstatus: Both
LLDP Operation TLV: portDecs sysName sysDesc sysCap
LLDP Trap Status: disable
LLDP maxRemote: 100
LLDP Overflow handle: discard
LLDP interface remote status : Full
8.15 show lldp neighbors interface ethernet
Command:
show lldp neighbors interface ethernet < IFNAME >
Function:
Display the LLDP neighbor information of the port.
Parameters:
None.