PLANET XGS3-24040 - Manual (Page 46)

XGS3 Command Guide
1-46
Switch#
1.1.8 enable password
Command:
enable password [8] <password>
no enable password
Function:
Configure the password used for enter Admin Mode from the User Mode,
The “no enable password” command deletes this password.
Parameter:
password is the configured code. Encryption will be performed by entering 8.
Command mode:
Global Mode
Default:
This password is empty by system default
Usage Guide:
Configure this password to prevent unauthorized entering Admin Mode. It is recommended to set the password at
the initial switch configuration. Also, it is recommended to exit Admin Mode with “exit” command when the
administrator needs to leave the terminal for a long time.
Example:
Set the Admin user password to “admin”.
Switch(config)#enable password 8 admin
1.1.9 end
Command:
end
Function:
Quit current mode and return to Admin mode when not at User Mode/ Admin Mode.
Command mode:
Except User Mode/ Admin Mode
Example:
Quit VLAN mode and return to Admin mode.
Switch(config-vlan1)#end
Switch#
1.1.10 exec-timeout
Command:
exec-timeout <minutes> [<seconds>]
no exec-timeout
Function: