PLANET XGS3-24040 - Manual (Page 814)

54-5
Displayed information
Explanation
State
Status
Virtual IP
Dummy IP address
Interface
Interface Name
Priority
Priority
Advertisement interval
Timer interval
Preempt
Preemptive mode
Circuit failover interface
Interface Monitor information
54.11 virtual-ip
Commands: virtual-ip <A.B.C.D>
no virtual-ip
Function: Configures the VRRP dummy IP address.
Parameters: <A.B.C.D> is the IP address in decimal format.
Default: Not configured by default.
Command mode: VRRP protocol configuration mode
Usage Guide: This command adds a dummy IP address to an existing Standby cluster. The "no
virtual-ip" command removes the dummy IP address from the specified Standby cluster. Each Standby
cluster can have only one dummy IP. VRRP priority as 255 (not configure), virtual-ip and interface ip
should in the same segment.
Special Notice: When updating to the newest version from 5.2.0.0 or an older one, the original VRRP
command configuration can’t be restored. Please delete the original configuration with “no router vrrp
<vrid>”, and then reconfigure. Otherwise, problems like suspended tasks may happen.
Example: Setting the backup dummy IP address to 10.1.1.1.
Switch(Config-Router-Vrrp)# virtual-ip 10.1.1.1