PLANET XGS3-24040 - Manual (Page 652)

XGS3 Command Guide
38-81
Switch# clear ip igmp snooping vlan 1 mrouter-port
Relative Command: show ip igmp snooping mrouter-port
38.10.3 debug igmp snooping
all/packet/event/timer/mfc
Command: debug igmp snooping all/packet/event/timer/mfc
no debug igmp snooping all/packet/event/timer/mfc
Function: Enable the IGMP Snooping switch of the switch; the “no debug igmp snooping
all/packet/event/timer/mfc” disables the debugging switch.
Command Mode: Admin Mode
Default: IGMP Snooping debugging switch is disabled on the switch by default.
Usage Guide: The command is used for enable the IGMP Snooping debugging switch of the switch,
switch IGMP data packet message can be shown with “packet” parameter, event message with “event”,
timer message with “time”, downsending hardware entries message with “mfc”, and all debugging
messages with “all”.
38.10.4 ip igmp snooping
Command: ip igmp snooping
no ip igmp snooping
Function: Enable the IGMP Snooping function; the “no ip igmp snooping” command disables this
function.
Command mode: Global Mode
Default: IGMP Snooping is disabled by default.
Usage Guide: Use this command to enable IGMP Snooping, that is permission every vlan config the
function of IGMP snooping. The “no ip igmp snooping” command disables this function.
Example: Enable IGMP Snooping.
Switch(config)#ip igmp snooping
38.10.5 ip igmp snooping vlan
Command: ip igmp snooping vlan <vlan-id>
no ip igmp snooping vlan <vlan-id>
Function: Enable the IGMP Snooping function for the specified VLAN; the “no ip igmp snooping vlan
<vlan-id>“ command disables the IGMP Snooping function for the specified VLAN.
Parameter: <vlan-id> is the VLAN number.
Command mode: Global Mode
Default: IGMP Snooping is disabled by default.
Usage Guide: To configure IGMP Snooping on specified vlan, the global IGMP Snooping should be first
enabled. Disable IGMP Snooping on specified vlan with the “no ip igmp snooping vlan <vlan-id>”
command.
Example: Enable IGMP Snooping for VLAN 100 in Global Mode.