PLANET XGS3-24040 - Manual (Page 820)

56-1
Chapter 56 Commands for MRPP
56.1 control-vlan
Command: control-vlan <vid>
no control-vlan
Function: Configure control VLAN ID of MRPP ring; the“no control-vlan” command deletes control
VLAN ID.
Parameter: <vid> expresses control VLAN ID, the valid range is from 1 to 4094.
Command Mode: MRPP ring mode
Default: None
Usage Guide: The command specifies Virtual VLAN ID of MRPP ring, currently it can be any value in
1-4094.To avoid confusion, it is recommended that the ID is non-configured VLAN ID, and the same to
MRPP ring ID. In configuration of MRPP ring of the same MRPP loop switches, the control VLAN ID must
be the same, otherwise the whole MRPP loop may can’t work normally or form broadcast.
The mrpp enable command must be start before the control-vlan command be used. If primary port,
secondary port, node-mode and enable commands all be configured after control-vlan, the mrpp-ring
function is enabled.
Example: Configure control VLAN of mrpp ring 4000 is 4000.
Switch(config)#mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
56.2 clear mrpp statistics
Command: clear mrpp statistics [<ring-id>]
Function: Clear statistic information of MRPP data packet of MRPP ring receiving and transferring.
Parameter: <ring-id> is MRPP ring ID, the valid range is from 1 to 4096, if not specified ID, it clears all of
MRPP ring statistic information.
Command Mode: Admin Mode.
Default: None.
Usage Guide: None.
Example: Clear statistic information of MRPP ring 4000 of switch.
Switch#clear mrpp statistics 4000
56.3 debug mrpp
Command: debug mrpp
no debug mrpp
Function: Open MRPP debug information; “no description” command disables MRPP debug
information.
Command Mode: Admin Mode
Parameter: None.
Usage Guide: Enable MRPP debug information, and check message process of MRPP protocol and
receive data packet process, it is helpful to monitor debug.