PLANET XGS3-24040 - Manual (Page 827)

Commands for Reliability Chapter 4 Commands for ULPP
57-2
57.4 debug ulpp event
Command: debug ulpp event
no debug ulpp event
Function: Show the event information of ULPP. The no operation disables showing the event information
of ULPP.
Parameter: None.
Default: Do not display.
Command mode: Admin mode.
Usage Guide: None.
Example: Show the event information of ULPP.
Switch# debug ulpp event
ULPP group 1 state changes：
Master port ethernet 1/1 in ULPP group 1 changed state to Forwading.
Slave port ethernet 1/2 in ULPP group 1 changed state to Standby.
57.5 debug ulpp flush content interface
Command: debug ulpp flush content interface <name>
no debug ulpp flush content interface <name>
Function: Show the contents of the receiving flush packets. The no operation disables the shown
contents.
Parameter: <name> is the name of the port.
Default: Do not display.
Command mode: Admin mode.
Usage Guide: None.
Example: Show the contents of the receiving flush packets for the port1/1.
Switch# debug ulpp flush content interface e1/1
Flush packet content:
Destination MAC: 01-03-0f-cc-cc-cc
Source MAC: 00-a0-cc-d7-5c-ea
Type: 8100
Vlan ID: 1
Length: 518
Control Type: 2
Control Vlan: 10
MAC number:0
Vlan Bitmap:
57.6 debug ulpp flush {send | receive} interface
Command: debug ulpp flush {send | receive} interface <name>
no debug ulpp flush {send | receive} interface <name>