PLANET XGS3-24040 - Manual (Page 59)

XGS3 Command Guide
1-59
1.2.5 authentication securityipv6
Command:
authentication securityipv6 <ipv6-addr>
no authentication securityipv6 <ipv6-addr>
Function:
To configure the trusted IPv6 address for Telnet and HTTP login method. The no form of this command will remove
the specified configuration.
Parameters:
<ipv6-addr> is the trusted IPv6 address which can login the switch.
Default:
No trusted IPv6 addresses are configured by default.
Command Mode:
Global Mode.
Usage Guide:
IPv6 address of the client which can login the switch is not restricted before the trusted IPv6 address is not
configured. After the trusted IPv6 address is configured, only clients with trusted IPv6 addresses are able to login the
switch. Up to 32 trusted IPv6 addresses can be configured in the switch.
Example:
Configure the secure IPv6 address is 2001:da8:123:1::1.
Switch(config)# authentication securityipv6 2001:da8:123:1::1
1.2.6 terminal length
Command:
terminal length <0-512>
terminal no length
Function:
Set columns of characters displayed in each screen on terminal; the “terminal no length” cancels the screen
switching operation and display content once in all.
Parameter:
Columns of characters displayed in each screen, ranging between 0-512 (0 refers to non-stop display).
Command mode:
Admin Mode.
Default:
Default columns is 25.
Usage guide:
Set columns of characters displayed in each screen on terminal, so that the-More-message will be shown when
displayed information exceeds the screen. Press any key to show information in next screen. 25 columns by default.
Example:
Configure treads in each display to 20.
Switch#terminal length 20