PLANET XGS3-24040 - Manual (Page 77)

XGS3 Command Guide
1-77
1.4.13 snmp-server enable traps
Command:
snmp-server enable traps
no snmp-server enable traps
Function:
Enable the switch to send Trap message; the “no snmp-server enable traps” command disables the switch to send
Trap message.
Command mode:
Global Mode
Default:
Trap message is disabled by default.
Usage Guide:
When Trap message is enabled, if Down/Up in device ports or of system occurs, the device will send Trap messages
to NMS that receives Trap messages.
Example:
Enable to send Trap messages.
Switch(config)#snmp-server enable traps
Disable to send Trap messages.
Switch(config)#no snmp-server enable traps
1.4.14 snmp-server engineid
Command:
snmp-server engineid <engine-string>
no snmp-server engineid
Function:
Configure the engine ID; the “no" form of this command restores to the default engine ID.
Command Mode:
Global mode
Parameter:
<engine-string> is the engine ID shown in 1-32 digit hex characters.
Default:
Default value is the company ID plus local MAC address.
Usage Guide:
None
Example:
Set current engine ID to A66688999F
Switch(config)#snmp-server engineid A66688999F
Restore the default engine ID
Switch(config)#no snmp-server engineid