PLANET XGS3-24040 - Manual (Page 481)

33-194
33.53 show ip ospf
Command:
show ip ospf [<process-id>]
Function:
Display OSPF main messages.
Parameter:
<process-id> is the process ID, ranging between 0~65535.
Default:
Not displayed
Command Mode:
Admin and configuration mode
Example:
Switch#show ip ospf
Routing Process "ospf 0" with ID 192.168.1.1
Process bound to VRF default
Process uptime is 2 days 0 hour 30 minutes
Conforms to RFC2328, and RFC1583Compatibility flag is disabled
Supports only single TOS(TOS0) routes
Supports opaque LSA
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Refresh timer 10 secs
Number of external LSA 0. Checksum Sum 0x000000
Number of opaque AS LSA 0. Checksum Sum 0x000000
Number of non-default external LSA 0
External LSA database is unlimited.
Number of LSA originated 0
Number of LSA received 0
Number of areas attached to this router: 1
Area 0 (BACKBONE) (Inactive)
Number of interfaces in this area is 0(0)
Number of fully adjacent neighbors in this area is 0
Area has message digest authentication
SPF algorithm executed 0 times
Number of LSA 0. Checksum Sum 0x000000
Routing Process "ospf 10" with ID 0.0.0.0
Process bound to VRF DC1
Process uptime is 4 days 23 hours 51 minutes
Conforms to RFC2328, and RFC1583Compatibility flag is disabled
Supports only single TOS(TOS0) routes
Supports opaque LSA
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Refresh timer 10 secs
Number of external LSA 0. Checksum Sum 0x000000