PLANET XGS3-24040 - Manual (Page 710)

XGS3 Command Guide
39-42
Function: Configure the multicast source control access list used by the port, the no operation of this
command is used to delete the configuration.
Parameters: <8000-8099>: Source control access list number.
Default: Not configured.
Command Mode: Port Configuration Mode.
Usage Guide: This command can only be successfully configured when the IPv6 multicast source
control is globally enabled, after configuring this command, all the IPv6 multicast messages entering from
the port will be matched according to the configured access list, only when the message is matched as
permit, can it be received and forwarded, or it will be dropped.
Example:
switch(config)#inter ethernet 1/4
switch(Config-If-Ethernet1/4)#ipv6 multicast source-control access-group 8000
39.6.9 multicast destination-control
Command: multicast destination-control
no multicast destination-control
Function: Configure to globally enable IPv4 and IPv6 multicast destination control, after configuring this
command, IPv4 and IPv6 multicast destination control will take effect at the same time. The no operation
of this command is to recover and disable the IPv4 and IPv6 multicast destination control globally.
Parameters: None.
Default: Disabled.
Command Mode: Global Configuration Mode.
Usage Guide: Only after globally enabling the multicast destination control, the other destination control
configuration can take effect, the destination access list can be applied to ports, VLAN-MAC and SIP.
After configuring this command, IGMP-SNOOPING, MLD-SNOOPING and IGMP, MLD will match
according to the rules mentioned above when they try to add ports after receiving IGMP-REPORT and
MLD-REPORT.
Example:
switch(config)# multicast destination-control
39.6.10 show ipv6 multicast destination-control
Command: show ipv6 multicast destination-control [detail]
show ipv6 multicast destination-control interface <Interfacename> [detail]
show ipv6 multicast destination-control host-address <ipv6addr> [detail]
show ipv6 multicast destination-control <vlan-id> <mac> [detail]
Function: Display IPv6 multicast destination control configuration.
Parameters: detail: Whether to display detailed information.
<Interfacename>: Interface name.
<ipv6addr>: IPv6 address.
<vlan-id> : VLAN ID.