PLANET XGS3-24040 - Manual (Page 833)

Commands for Reliability Chapter 4 Commands for ULPP
57-8
Example: Disable receiving the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable arp
57.20 ulpp flush disable mac
Command: ulpp flush disable mac
Function: Disable receiving the flush packets of updating MAC address.
Parameter: None.
Default: By default, disable receiving the flush packets of updating MAC address.
Command mode: Port mode.
Usage Guide: If this command is configured, then it will not receive the flush packets of updating MAC
address.
Example: Disable receiving the flush packets of updating MAC address.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable mac
57.21 ulpp flush enable arp
Command: ulpp flush enable arp
Function: Enable receiving the flush packets of deleting ARP.
Parameter: None.
Default: By default, disable receiving the flush packets of deleting ARP.
Command mode: Port mode.
Usage Guide: Enable this function to receive the flush packets which delete ARP.
Example: Enable receiving of the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush enable arp
57.22 ulpp flush enable mac
Command: ulpp flush enable mac
Function: Enable receiving the flush packets of updating MAC address.
Parameter: None.
Default: By default, disable receiving the flush packets of updating MAC address.
Command mode: Port mode.
Usage Guide: Enable receiving the flush packets of updating MAC address table.
Example: Enable receiving the flush packets of updating the MAC address.