PLANET XGS3-24040 - Manual (Page 394)

29-107
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set community local-as additive
29.20 set extcommunity
Command:
set extcommunity <rt | soo> <AA:NN>
no set extcommunity <rt | soo> [<AA:NN>]
Function:
Configure the extended community attributes of the BGP routing message. The “no set
extcommunity <rt | soo> [<AA:NN>]” command deletes this configuration.
Parameter:
<rt> is the route target, <soo> is the site of origin, <AA:NN> is the value of community attributes,
amongst AA is AS number, NN is a random two byte number.
Command Mode:
route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set extcommunity rt 100:10
29.21 set ip next-hop
Command:
set ip next-hop <ip_addr>
no set ip next-hop [<ip_addr>]
Function:
Configure the next-hop of the route. The “no set ip next-hop [<ip_addr>]” command deletes the
configuration.
Parameter:
<ip_addr > is the ip address of next-hop shown with dotted decimal notation.
Command Mode:
route-map mode