PLANET XGS3-24040 - Manual (Page 376)

28-89
28.8 ipv6 dhcp snooping binding nd
Command:
ipv6 dhcp snooping binding nd
no ipv6 dhcp snooping binding nd
Function:
Globally enable the function that DHCPv6 Snooping binds ND. The no command disables the
function.
Parameters:
None.
Command Mode:
Globe mode
Default Settings:
Disable the function that DHCPv6 Snooping binds ND.
Usage Guide:
After this function is enabled globally, send static ND while setting up DHCPv6 Snooping binding,
and convert the already existent DHCPv6 Snooping binding into the static ND entry. After disable
the global DHCPv6 Snooping function, the static ND entries will not be set according to DHCPv6
Snooping binding, and all the corresponding static ND entries set by DHCP Snooping binding will be
deleted.
Example:
Send the static ND entries according to DHCPv6 Snooping binding.
switch(config)#ipv6 dhcp snooping binding nd
28.9 ipv6 dhcp snooping binding user
Command:
ipv6 dhcp snooping binding user mac <MAC-address> address <ipv6-address> vlan <vid>
interface [ethernet | port-channel] <ifname>
no ipv6 dhcp snooping binding user mac <MAC-address>
Function:
Users set the static binding entries. The no command deletes the list entry.
Parameters:
MAC-address: The MAC address
vid: VLAN ID, the range from 1 to 4094
ipv6-address: The IPv6 address
ifname: The access interface of the static binding user.
Command Mode:
Globe mode
Default Settings:
There is no static list entry.
Usage Guide:
Add the static list entry to the binding table. For DHCPv6 Snooping binding data, MAC address and
IPv6 address must ensure that have no conflict. The static binding data can cover the dynamic
binding data and can not be covered by the dynamic binding data.