PLANET XGS3-24040 - Manual (Page 334)

25-47
Command Mode:
Admin Mode.
Example:
Switch# debug ipv6 dhcp relay packet
25.6 debug ipv6 dhcp server
Command:
debug ipv6 dhcp server { event | packet }
no debug ipv6 dhcp server { event | packet }
Function:
To enable the debugging information of DHCPv6 server, the no form of this command will disable
the debugging.
Parameter:
event is to enable debugging messages for DHCPv6 server events, such as address allocation;
packet is for debugging messages of protocol packets of DHCPv6 server.
Default:
Disabled.
Command Mode:
Admin Mode.
Example:
Switch#debug ipv6 dhcp server packet
25.7 dns-server
Command:
dns-server <ipv6-address>
no dns-server <ipv6-address>
Function:
To configure the IPv6 address of the DNS server for DHCPv6 client; the no form of this command
will remove the DNS configuration.
Parameter:
<ipv6-address> is the IPv6 address of DNS Server.
Default:
No configured address pool of DNS Server by default.
Command Mode:
DHCPv6 Address Pool Configuration Mode.
Usage Guide:
For each address pool, at most three DNS server can be configured, and the addresses of the DNS
server must be valid IPv6 addresses.
Example:
To configure the DNS Server address of DHCPv6 client as 2001:da8::1.