PLANET XGS3-24040 - Manual (Page 538)

35-251
Switch(config-router)# neighbor 10.1.1.66 distribute-list 101 out
Related Command: ip access-list
35.53 neighbor dont-capability-negotiate
Command: neighbor {<ip-address>|<TAG>} dont-capability-negotiate
no neighbor {<ip-address>|<TAG>} dont-capability-negotiate
Function: Set to not perform capability negotiate in creating connections. The “no neighbor
{<ip-address>|<TAG>} dont-capability-negotiate” command cancels this configuration.
Parameter: <ip-address>: Neighbor IP address.
<TAG>: Name of the peer group.
Default: Capability negotiation performed.
Command Mode: BGP route mode and address-family mode
Usage Guide: As the negotiation is the default, it can be disabled with this configuration when it is known
that the partner BGP version is old which don’t support capability negotiation.
Example: Last addition capability negotiation will not be realized in the connection by configuring as
follows.
Switch(config-router)#neighbor 10.1.1.64 dont-capability-negotiate
35.54 neighbor ebgp-multihop
Command: neighbor {<ip-address>|<TAG>} ebgp-multihop [<1-255>]
no neighbor {<ip-address>|<TAG>} ebgp-multihop [<1-255>]
Function: Configures the EBGP neighbors can existing in different segment as well as its hop count
(TTL). The “no neighbor {<ip-address>|<TAG>} ebgp-multihop [<1-255>]” set that the EBGP
neighbors must be in the same segment.
Parameter: <ip-address>: Neighbor IP address.
<TAG>: Name of the peer group.
<1-255>: Allowed hop count.
Default: Must be in the same segment.
Command Mode: BGP route mode and address-family mode
Usage Guide: Without this command, EBGP peers are required to be in the same segment and after this
command is configured, peer addresses may from different segments. The allowed hop count can be
configured and will be 255 if not.
Example:
Three device 10.1.1.64(AS100) and 11.1.1.120(AS300) connected respectively to the two interface
10.1.1.66 and 10.1.1.100 of another device. IGP accessibilities of 10.1.1.64 and 11.1.1.120 on both side
routes are ensured through static configuration. The neighbor relationship is established only after both
side are configured as follows: