PLANET XGS3-24040 - Manual (Page 262)

17-20
Parameters:
None.
Command Mode：
Interface Configuration Mode.
Default:
Information other than the address information won’t be obtained via DHCPv6.
Examples:
Set IPv6 information other than the address information in interface vlan 1 will be obtained via
DHCPv6.
Switch#(Config-if-Vlan1)#ipv6 nd other-config-flag
17.2.25 ipv6 nd managed-config-flag
Command:
ipv6 nd managed-config-flag
Function:
Set the flag representing whether the address information will be obtained via DHCPv6.
Parameters:
None.
Command Mode：
Interface Configuration Mode.
Default:
The address information won’t be obtained via DHCPv6.
Examples:
Set IPv6 address information in interface vlan 1 will be obtained via DHCPv6.
Switch#(Config-if-Vlan1)#ipv6 nd managed-config-flag
17.2.26 ipv6 neighbor
Command:
ipv6 neighbor <ipv6-address> <hardware-address> interface <interface-type
interface-number>
no ipv6 neighbor <ipv6-address>
Function:
Set static neighbor table entry.
Parameters:
Parameter ipv6-address is static neighbor IPv6 address, same to interface prefix parameter,
parameter hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-number is Layer 2 interface name.
Command Mode:
Interface Configuration Mode
Default Situation:
There is not static neighbor table entry.