10 ntp broadcast client, 11 ntp multicast client, 12 ntp ipv6 multicast client – PLANET XGS3-24040 User Manual
Page 843: Ntp broadcast client, Ntp multicast client, Ntp ipv, Multicast client
60-4
60.10 ntp broadcast client
Command: ntp broadcast client
no ntp broadcast client
Function: To configure/cancel the specified port to receive NTP broadcast packets.
Parameter: None.
Default: Disabled.
Command Mode: Interface Configuration Mode.
Usage Guide: None.
Example: To enable the function of VLAN1 interface to receive NTP broadcast packets.
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)#ntp broadcast client
60.11 ntp multicast client
Command: ntp multicast client
no ntp multicast client
Function: To configure/cancel the specified port to receive NTP multicast packets.
Parameter: None.
Default: Disabled.
Command Mode: Interface Configuration Mode.
Usage Guide: None.
Example: To enable the function of VLAN1 interface to receive NTP multicast packets.
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)#ntp multicast client
60.12 ntp ipv6 multicast client
Command: ntp ipv6 multicast client
no ntp ipv6 multicast client
Function: To configure/cancel the specified port to receive NTP multicast packets of IPv6.
Parameter: None.
Default: Disabled.
Command Mode: Interface Configuration Mode.
Usage Guide: None.
Example: To enable the function of VLAN1 interface to receive NTP multicast packets of IPv6.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ntp ipv6 multicast client