PLANET XGS3-24040 - Manual (Page 544)

35-257
Parameter: <ip-address>: Neighbor IP address.
<TAG>: Name of the peer group.
<0-65535>: TCP port number.
Default: Default port number is 179.
Command Mode: BGP route mode and address-family mode
Usage Guide: This is a configuration when the partner may connect through ports not specified by BGP.
Example:
Switch(config-router)#neighbor 10.1.1.64 port 1023
35.65 neighbor prefix-list
Command: neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in|out>}
no neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in>|<out>}
Function: Configure the prefix restrictions applied in sending or receiving routes from specified
neighbors.The “no neighbor {<ip-address>|<TAG>} prefix-list <LISTNAME|number> {<in>|<out>}”
command cancels this configuration.
Parameter: <ip-address>: Neighbor IP address.
<TAG>: Name of the peer group.
<LISTNAME|number>: Name or sequence number of the prefix-list.
<in|out>: Direction on which the restrictions applied.
Default: No prefix restrictions applied.
Command Mode: BGP route mode and address-family mode
Usage Guide: Specify the prefix and its scope by configuring ip prefix-list and determines whether this
scope is permitted or denied. Only the route with permitted prefix will be sent or received.
Example:
Switch(config)#ip prefix-list prw permit 100.1.0.0/22 ge 23 le 25
Switch(config)#router bgp 200
Switch(config-router)#redistribute static
Switch(config-router)neighbor 10.1.1.66 prefix-list prw out
35.66 neighbor remote-as
Command: neighbor {<ip-address>|<TAG>} remote-as <as-id>
no neighbor {<ip-address>|<TAG>} [remote-as <as-id>]
Function: Configure the BGP neighbor. The “no neighbor {<ip-address>|<TAG>} [remote-as
<as-id>]” command is used for deleting BGP neighbors.
Parameter: <ip-address>: Neighbor IP address