PLANET XGS3-24040 - Manual (Page 589)

XGS3 Command Guide
38-18
configure PIM-SM information about candidate BSR in order to compete the BSR router with other
candidate BSRs. Only this command is configured , this switch is the BSR candidate router.
Example:Globally configure the interface vlan1 as the candidate BSR-message transmitting interface.
Switch (config)# ip pim bsr-candidate vlan1 30 10
38.3.14 ip pim cisco-register-checksum
Command: ip pim cisco-register-checksum [group-list <simple-acl>]
no ip pim cisco-register-checksum [group-list <simple-acl>]
Function: Configure the register packet’s checksum of the group specified by myfilter to use the whole
packet’s length.
Default: Compute the checksum according to the register packet’s head length, default: 8
Parameter: <simple-acl>: <1-99> Simple access-list <simple-acl>: <1-99> Simple access-list
Command Mode: Global Mode
Usage Guide: This command is used to interact with older Cisco IOS version.
Example: Configure the register packet’s checksum of the group specified by myfilter to use the whole
packet’s length.
Switch (config)#ip pim cisco-register-checksum group-list 23
38.3.15 ip pim dr-priority
Command: ip pim dr-priority <priority>
no ip pim dr-priority
Function: Configure, disable or change the interface’s DR priority. The neighboring nodes in the same
net segment select the DR in their net segment according to hello packets. The “no ip pim dr-priority”
command restores the default value.
Parameter: <priority> is priority
Default: 1
Command Mode: Interface Configuration Mode
Usage Guide: Range from 0 to 4294967294, the higher value has more priority.
Example: Configure vlan’s DR priority to 100
Switch (config)# interface vlan 1
Switch(Config-if-Vlan1)ip pim dr-priority 100
Switch (Config -if-Vlan1)#
38.3.16 ip pim exclude-genid
Command: ip pim exclude-genid
no ip pim exclude-genid
Function: This command makes the Hello packets sent by PIM SM do not include GenId option. The “no