PLANET XGS3-24040 - Manual (Page 693)

XGS3 Command Guide
39-25
Default: Disabled PIM-SM
Command Mode: Interface Configuration Mode
Usage Guide: Enable PIM-SM on the interface. The command can configure on IPv6 tunnel interface,
but it is successful configuration to only configure tunnel carefully.
Example: Enable PIM-SM on the interface vlan1.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 pim sparse-mode
39.3.32 show ipv6 pim bsr-router
Command: show ipv6 pim bsr-router
Function: Display BSR address.
Parameter: None
Default: None
Command Mode: Admin Mode and Global Mode
Example:
Switch#show ipv6 pim bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (BSR)
BSR address: 2000:1:111::100 (?)
Uptime: 00:16:00, BSR Priority: 0, Hash mask length: 126
Next bootstrap message in 00:00:10
Role: Candidate BSR
State: Elected BSR
Next Cand_RP_advertisement in 00:00:10
RP: 2000:1:111::100(Vlan2)
Displayed Information
Explanations
BSR address
Bsr-router Address
Priority
Bsr-router Priority
Hash mask length
Bsr-router hash mask length
State
The current state of this candidate BSR, Elected
BSR is selected BSR