PLANET XGS3-24040 - Manual (Page 109)

XGS3 Command Guide
4-109
on a
10/100/1000
port working
at a speed
of 100M.
Example:
Set the bandwidth limit of 1/1-8 port is 40000K.
Switch(config)#interface ethernet 1/1-8
Switch(Config-If-Port-Range)#bandwidth control 40000 both
4.1.2 combo-forced-mode
Command:
combo-forced-mode {copper-forced | copper-preferred-auto | sfp-forced | sfp-preferred-auto }
Function:
Sets to combo port mode (combo ports only).
Parameters:
copper-forced forces use of copper cable port; copper-preferred-auto for copper cable port first; sfp-forced forces
use of fiber cable port; sfp-preferred-auto for fiber cable port first.
Command mode:
Port Mode.
Default:
The default setting for combo mode of combo ports is fiber cable port first.
Usage Guide:
The combo mode of combo ports and the port connection condition determines the active port of the combo ports. A
combo port consists of one fiber port and a copper cable port. It should be noted that the speed-duplex command
applies to the copper cable port while the negotiation command applies to the fiber cable port, they should not conflict.
For combo ports, only one, a fiber cable port or a copper cable port, can be active at a time, and only this port can
send and receive data normally.
For the determination of the active port in a combo port, see the table below. The headline row in the table indicates
the combo mode of the combo port, while the first column indicates the connection conditions of the combo port, in
which “connected” refers to a good connection of fiber cable port or copper cable port to the other devices.
Copper forced
Copper preferred
SFP forced
SFP preferred