9 show arp-dynamic count, 10 show nd-dynamic count, Show arp – PLANET XGS3-24040 User Manual
Page 769: Dynamic count, Show nd
43-5
Command Mode: Admin and Configuration Mode.
Usage Guide: Use this command to display the number of dynamic MAC of corresponding port and
VLAN.
Examples: Display the number of dynamic MAC of the port and VLAN which are configured with number
limitation function of MAC.
Switch(config)# show mac-address dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show mac-address dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
43.9 show arp-dynamic count
Command: show arp-dynamic count { (vlan <1-4096>)| interface ethernet <portName>}
Function: Display the number of dynamic ARP of corresponding port and VLAN.
Parameters: <vlan-id> is play the specified vlan ID.
<portName> is the name of layer-2 port.
Command Mode: Admin and Configuration Mode.
Usage Guide: Use this command to display the number of dynamic ARP of corresponding port and
VLAN.
Examples: Display the number of dynamic ARP of the port and VLAN which are configured with number
limitation function of ARP.
Switch(config)# show arp-dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show arp-dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
43.10 show nd-dynamic count
Command: show nd-dynamic count {(vlan <1-4096>)| interface ethernet <portName>}
Function: Display the number of dynamic ND of corresponding port and VLAN.
Parameters: <vlan-id> is play the specified vlan ID. <portName> is the name of layer-2 port.