PLANET XGS3-24040 - Manual (Page 807)

Commands for Reliability Content
53-3
Parameter:<interval-value> is the value of the interval with a valid range of 20~120 and shown in
second.
Command Mode: Port Mode
Default: No default value
Usage Guide: If no statistic sampling interval is configured, there will not be any statistic sampling on the
interface.
Example: Set the statistic sampling interval on the interface e1/1 to 20 seconds.
Switch(Config-If-Ethernet1/1)#sflow counter-interval 20
53.7 sflow rate
Command: sflow rate { input <input-rate> | output <output-rate >}
no sflow rate [input | output]
Function: Configure the sample rate of the sFlow hardware sampling. The “no” form of this command
deletes the sampling rate value.
Parameter: <input-rate> is the rate of ingress group sampling, the valid range is 1000~16383500.
<output-rate> is the rate of egress group sampling, the valid range is 1000~16383500.
Command Mode: Port Mode.
Default: No default value.
Usage Guide: The traffic sampling will not be performed if the sampling rate is not configured on the port.
And if the ingress group sampling rate is set to 10000, this indicates there will be one group be sampled
every 10000 ingress groups.
Example: Configure the ingress sample rate on port e1/1 to 10000 and the egress sample rate to 20000.
Switch(Config-If-Ethernet1/1)#sflow rate input 10000
Switch(Config-If-Ethernet1/1)#sflow rate output 20000
53.8 show sflow
Command: show sflow
Function: Display the sFlow configuration state.
Parameter: None.
Command Mode: All Modes.
Usage Guide: This command is used to acknowledge the operation state of sFlow.
Switch#show sflow
Sflow version 1.2
Agent address is 172.16.1.100
Collector address have not configured
Collector port is 6343
Sampler priority is 2
Sflow DataSource: type 2, index 194(Ethernet1/2)
Collector address is 192.168.1.200
Collector port is 6343