PLANET XGS3-24040 - Manual (Page 828)

Commands for Reliability Chapter 4 Commands for ULPP
57-3
Function: Show the information of the receiving/sending flush packets, it only shows the receiving
packets, but do not show the detailed contents of the packets. The no operation disables the shown
information.
Parameter: <name> is the name of the port.
Default: Do not display.
Command mode: Admin mode.
Usage Guide: None.
Example: Show the information that send the flush packets for the port1/1.
Switch# debug ulpp flush send interface e1/1
Flush packet send on port Ethernet 1/1.
57.7 description
Command: description <string>
no description
Function: Configure the description character string of ULPP group. The no command deletes the
description.
Parameter: <string> is the name of ULPP group, the max number of the characters is 128.
Default: Do not configure ULPP name by default.
Command mode: ULPP group configuration mode.
Usage Guide: None.
Example: Configure the description of ULPP group as PLANET.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# description PLANET
57.8 flush disable arp
Command: flush disable arp
Function: Disable sending the flush packets of deleting ARP.
Parameter: None.
Default: By default, enable the sending function of the flush packets which are deleted by ARP.
Command mode: ULPP group configuration mode.
Usage Guide: If configure this command, when the link is switched, it will not actively send the flush
packets to notify the upstream device to delete the entries of ARP.
Example: Disable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable arp