PLANET XGS3-24040 - Manual (Page 819)

55-5
Interface name.
Priority
Priority.
Advertisement interval
The interval of VRRPv3 advertisement messages.
Preempt
Preempt mode.
Circuit failover interface
Monitor interface information.
55.10 virtual-ipv6 interface
Command: virtual-ipv6 <ipv6-address> interface {Vlan <ID>| IFNAME}
no virtual-ipv6 interface
Function: Configure the virtual IPv6 address and interface of VRRPv3.
Parameters: <ipv6-address>is the virtual IPv6 address, which has to be an IPv6 local link address.
{Vlan <ID>| IFNAME} is the interface name.
Command Mode: VRRPv3 Protocol Mode.
Default: There is no configuration by default.
Usage Guide: This command is used to add an IPv6 address and interface to an existing backup group.
The no operation of this command will delete the virtual IPv6 address and interface of the specified
backup group. The virtual IPv6 address is the link local unicast address. There can only be one virtual
IPv6 address in a backup group. In order to avoid the fault of returning physical MAC address when Ping
virtual IPv6 address, it is regulated that the virtual IPv6 address should not be the real IPv6 address of
the interface. Thus, the interfaces of all VRRPv3 backup groups are Backup by default, and need to
select a Master within the backup groups.
Example: Configure the virtual IPv6 address of the backup group as fe80::2, the interface is VLAN1.
Switch(config-router)# virtual-ipv6 fe80::2 interface vlan 1